Tianjin Botai Heat Exchange Equipment Co.,Ltd
Plate heat exchanger Manufacturer: What problems are commonly encountered with Tianjin plate heat exchangers?
2020-09-01
Plate heat exchanger Manufacturer: What problems can Tianjin plate heat exchangers easily cause? 1. Blockage issue When the heat exchanger is in operation, if the pressure drop before and after increases, and the pressure parameters exceed 0.1MP, it may indicate that the heat exchanger is experiencing blockage. At this point, it is necessary to stop work, clean, and remove debris.
Plate Heat Exchanger Manufacturer:Tianjin Plate Heat ExchangerWhat problems can easily occur
1. Blockage problem
When the heat exchanger is working, the pressure loss before and after increases, and if the pressure parameters exceed 0.1MP, it may indicate that the heat exchanger may be blocked. At this time, it is necessary to stop work, clean, and remove debris.
2. Internal gas not discharged from the heat exchanger
During the trial operation after installation, it is important to check whether there is a large amount of air inside. The exhaust system should be checked, and only after exhausting the air can formal operation proceed.
3. Water quality issues in the system, leading toTianjin Plate Heat Exchangerinternal scaling
In the face of this situation, one method is to shut down the machine, disassemble it, and clean it. The other method is chemical cleaning.
4. Heat exchanger leakage
If the heat exchanger leaks, the pressure before and after will be consistent, indicating that water is leaking internally. Internal leaks require timely replacement of plates; external leaks require replacement of sealing gaskets.
The above isPlate Heat Exchanger Manufacturerthe complete content prepared for everyone regarding the common problems that may occur with Tianjin plate heat exchangers. I hope the relevant introductions in the article can provide everyone with a new understanding of plate heat exchangers.
Previous Page: